Datacap Logo

Verifone P400 - Static IP

What do I need to connect the P400?

  • Verifone P400 PIN Pad
  • Verifone P400 Ethernet cable
  • Verifone P400 Power Supply
Verifone P400

1.) Press the “1”, “5”, and “9” keys at the same time to open settings.

P400 Settings

2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).

P400 Control Panel

3.) Select “Sysmode” (scroll down if needed by dragging your finger upward).

Sysmode

4.) Select “supervisor”.

Supervisor P400

5.)  Type the supervisor password and press the “Enter (green)” key. This password can vary.

  • “1111111” 
    OR
  • “1166832” 
    OR
  • “1668321”
    OR
  • “1686321”
P400 password

6.) Select “Administration”.

Adminstration

7.) Select “Config Editor”.

Admin Menu P400

8.) Select “config.usr1”.

usr1

9.) Select “sacom” by touching its current value (scroll down if needed by dragging your finger upward).

Saucom

10.) Select “Modify”.

Modify

11.) Type “IP” (To cycle through lower case, upper case, and number press the “#” key)

IP

12.) Press the “Enter (green)” key.

13.) Press the “Cancel(red)” key 2 times to reach the administration menu.

14.) Select “Communications”.

Admin Menu P400

15.) Select “Ethernet”.

16.) Select “eth0″.

Eth0

17.) Select “Mode”.

Mode

18.) Enter your static values for the following fields:

  • IP Address
  • Mask
  • Gateway
  • DNS1
  • DNS2
Eth0 Settings

19.) Press the “Cancel (red)” key.

20.) If prompted “Do you want to save changes?” select “Ok”.

Save pages

21.) If prompted “Configure another interface? Select “No”.

22.) Press the “Cancel (red)” key twice to reach the main menu.

23.) Select “Exit”.

Exit

24.) Select “Reboot”.

Reboot