P400-Ethernet

Verifone P400 - Ethernet

What do I need to connect the P400?

Verifone P400 PIN Pad
Verifone P400 Ethernet cable
Verifone P400 Power Supply

1.) Press the “1”, “5”, and “9” keys at the same time to open settings.

2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).

3.) Select “Sysmode” (scroll down if needed by dragging your finger upward).

4.) Select “supervisor”.

5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.

“1111111”
OR
“1166832”
OR
“1668321”
OR
“1686321”
OR
“1673491”

6.) Select “Administration”.

7.) Select “Config Editor”.

8.) Select “config.usr1”.

9.) Select “sacom” by touching its current value.

10.) Select “Modify”.

11.) Type “IP” (To cycle through lower case, upper case, and number press the “#” key).

12.) Press the “Enter (green)” key.

13.) Press the “Cancel (red)” key 3 times to reach the Main menu.

14.) Select “Exit”.

15.) Select “Reboot”.

Note: The P400 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.

Contact us

100 New Britain Blvd.
Chalfont, PA 18914

Phone: 215-997-8989
E-mail: sales@dcap.com

Hours of operation:
Monday – Friday 8:30am to 5:30pm EST

Datacap supports regulatory best practices in ADA and EMV with support of the Kiosk Industry Group and the Kiosk Association (KMA). The KMA works directly with the U.S. Access Board and is a participating organization with PCI SSC.