P200 - Static IP - Datacap Systems, Inc.

Verifone P200 - Static IP

What do I need to connect the P200?

Verifone P200 PIN Pad
Verifone P200 Ethernet cable
Verifone P200 Power Supply

1.) Press the “1”, “5”, and “9” keys at the same time to open settings.

2.) Select “Control Panel” (scroll up/down by using the Direction Pad).

3.) Select “Sysmode”.

4.) Select “supervisor”.

5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.

“1111111”
OR
“1166832”
OR
“1668321”
OR
“1686321”

6.) Select “Administration”.

7.) Select “Config Editor”.

8.) Select “config.usr1”.

9.) Select “sacom” by touching its current value (scroll down if needed by dragging your finger upward).

10.) Select “Modify”.

11.) Type “IP” (To cycle through lower case, upper case, and number press the “#” key)

12.) Press the “Enter (green)” key.

13.) Press the “Cancel(red)” key 2 times to reach the administration menu.

14.) Select “Communications”.

15.) Select “Ethernet”.

16.) Select “eth0″.

17.) Select “Mode”.

18.) Enter your static values for the following fields:

IP Address
Mask
Gateway
DNS1
DNS2

19.) Press the “Cancel (red)” key.

20.) If prompted “Do you want to save changes?” select “Ok”.

21.) If prompted “Configure another interface? Select “No”.

22.) Press the “Cancel (red)” key twice to reach the main menu.

23.) Select “Exit”.

24.) Select “Reboot”.

Note: The P200 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.

Company

Become a Datacap Reseller

Direct Rental Program

Solutions

White-Labeled Gateway

Compatible Devices

Supported Processors

Resources

Developer Portal

Reporting Dashboard

Merchant Parameter WS

Support Articles

Contact us

100 New Britain Blvd.
Chalfont, PA 18914

Phone: 215-997-8989
E-mail: sales@dcap.com

Hours of operation:
Monday – Friday 8:30am to 5:30pm EST

© 2024 Datacap Systems, Inc. All Rights Reserved | Privacy Policy | Terms of Use

Datacap supports regulatory best practices in ADA and EMV with support of the Kiosk Industry Group and the Kiosk Association (KMA). The KMA works directly with the U.S. Access Board and is a participating organization with PCI SSC.