1.) Press the “1”, “5”, and “9” keys at the same time to open settings.
2.) Select “Control Panel” (scroll up/down using the Direction pad).
Direction Pad on the P200
3.) Select “Sysmode” (scroll down if needed by dragging your finger upward).
4.) Select “supervisor”.
5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.
“1111111” OR
“1166832” OR
“1668321” OR
“1686321”
6.) Select “Administration”.
7.) Select “Config Editor”.
8.) Select “config.usr1”.
9.) Select “sacom” by touching its current value.
10.) Select “Modify”.
11.) Type “IP” (To cycle through lower case, upper case, and number press the “#” key).
12.) Press the “Enter (green)” key.
13.) Press the “Cancel (red)” key 3 times to reach the Main menu.
14.) Select “Exit”.
15.) Select “Reboot”.
Note: The P200 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.