M400 Static IP

Verifone M400 - Static IP

What do I need to connect the M400?

Verifone M400 PIN Pad
Verifone M400 Ethernet cable
Verifone M400 Power Supply

1.) Press the “1”, “5”, and “9” keys at the same time to open settings.

2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).

3.) Select “Sysmode”.

4.) Select “supervisor”.

5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.

“1111111”
OR
“1166832”
OR
“1668321”
OR
“1686321”

6.) Select “Administration”.

7.) Select “Config Editor”.

8.) Select “config.usr1”.

9.) Select “sacom” by touching its current value (scroll down if needed by dragging your finger upward).

10.) Select “Modify”.

11.) Type “IP”.

12.) Press the “Enter (green)” key.

13.) Press the “Cancel(red)” key 2 times to reach the administration menu.

14.) Select “Communications”.

15.) Select “Ethernet”.

16.) Select “eth0″.

17.) Select “Mode” and select “Static”.

18.) Enter your static values for the following fields:

IP Address
Mask
Gateway
DNS1
DNS2

19.) Press the “Cancel (red)” key.

20.) If prompted “Do you want to save changes?” select “Ok”.

21.) If prompted “Configure another interface? Select “No”.

22.) Press the “Cancel (red)” key twice to reach the main menu.

23.) Select “Exit”.

24.) Select “Reboot”.

Note: The M400 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.

Verifone M400 - Static IP

What do I need to connect the M400?

1.) Press the “1”, “5”, and “9” keys at the same time to open settings.

2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).

3.) Select “Sysmode”.

4.) Select “supervisor”.

5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.

6.) Select “Administration”.

7.) Select “Config Editor”.

8.) Select “config.usr1”.

9.) Select “sacom” by touching its current value (scroll down if needed by dragging your finger upward).

10.) Select “Modify”.

11.) Type “IP”.

12.) Press the “Enter (green)” key.

13.) Press the “Cancel(red)” key 2 times to reach the administration menu.

14.) Select “Communications”.

15.) Select “Ethernet”.

16.) Select “eth0″.

17.) Select “Mode” and select “Static”.

18.) Enter your static values for the following fields:

19.) Press the “Cancel (red)” key.

20.) If prompted “Do you want to save changes?” select “Ok”.

21.) If prompted “Configure another interface? Select “No”.

22.) Press the “Cancel (red)” key twice to reach the main menu.

23.) Select “Exit”.

24.) Select “Reboot”.

Company

Solutions

Resources

Contact us