1.) Press the “1”, “5”, and “9” keys at the same time to open settings.
2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).
3.) Select “Sysmode”.
4.) Select “supervisor”.
5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.
“1111111” OR
“1166832” OR
“1668321” OR
“1686321”
6.) Select “Administration”.
7.) Select “Config Editor”.
8.) Select “config.usr1”.
9.) Select “sacom” by touching its current value.
10.) Select “Modify”.
11.) Type “IP” .
12.) Press the “Enter (green)” key.
13.) Press the “Cancel (red)” key 3 times to reach the Main menu.
14.) Select “Exit”.
15.) Select “Reboot”.
Note: The M400 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.