Lane/7000 - ethernet - Datacap Systems, Inc.

Ingenico Lane/7000 – Static IP

What do I need to set-up the Lane/7000?

Ingenico Lane/7000
Lane/7000 power supply
Lane/7000 Ethernet cable
TranCloud Unit
TranCloud power supply
IP Address for wireless Network (What’s this?)
Gateway Address for wireless Network (What’s this?)

1.) Connect Lane/7000 Ethernet cable to the back of the Ingenico Lane/7000 and into one of the LAN ports on your internet router.

Note: The make/model of your internet router and the Ethernet cables connected to it will look different than the one used to make this guide.

2.) Connect Lane/7000 power supply to 120V power outlet and to the back of the Lane/7000 Ethernet cable.

3.) Once the Lane/7000 is on, press 0-0-0-1, to access the Admin menu.

4.) Select “Ethernet Parameters”.

5.) Select “IP Configuration”.

6.) Select “DHCP activation”. Select “Off” then press “Enter (Green)” key.

7.) Select “IP address”. Enter the static IP assigned to the device then press “Enter (Green)” key.

8.) Select “Subnet mask”. Enter the subnet mask of the LAN this device is connected to then press “Enter (Green)” key.

9.) Press “Cancel (Red)” key once.

10.) Press “Enter (Green)” key when prompted to save changes.

11.) Press “Cancel (Red)” key once. The device should reboot.

Company

Become a Datacap Reseller

Direct Rental Program

Solutions

White-Labeled Gateway

Compatible Devices

Supported Processors

Resources

Developer Portal

Reporting Dashboard

Merchant Parameter WS

Support Articles

Contact us

100 New Britain Blvd.
Chalfont, PA 18914

Phone: 215-997-8989
E-mail: sales@dcap.com

Hours of operation:
Monday – Friday 8:30am to 5:30pm EST

© 2024 Datacap Systems, Inc. All Rights Reserved | Privacy Policy | Terms of Use

Datacap supports regulatory best practices in ADA and EMV with support of the Kiosk Industry Group and the Kiosk Association (KMA). The KMA works directly with the U.S. Access Board and is a participating organization with PCI SSC.