Datacap Logo

Ingenico Lane/3000 – Static IP

What do I need to set-up the Lane/3000?

  • Ingenico Lane/3000

  • Lane/3000 power supply

  • Lane/3000 Ethernet cable

  • TranCloud Unit

  • TranCloud power supply

  • IP Address for wireless Network (What’s this?)

  • Gateway Address for wireless Network (What’s this?)

1.)  Connect Lane/3000 Ethernet cable to the back of the Ingenico Lane/3000 and into one of the LAN ports on your internet router.

Router

2.)  Connect Lane/3000 power supply to 120V power outlet and to the back of the Lane/3000 Ethernet cable.

3.)  Once the Lane/3000 is on, press 0-0-0-1, to access the Admin menu.

Admin Mode

4.)  Select “Ethernet Parameters”.

5.)  Select “IP Configuration”.

6.)  Select “DHCP activation”. Select “Off” then press “Enter (Green)” key.

7.)  Select “IP address”. Enter the static IP assigned to the device then press “Enter (Green)” key.

8.)  Select “Subnet mask”. Enter the subnet mask of the LAN this device is connected to then press “Enter (Green)” key.

9.)  Press “Cancel (Red)” key once.

10.)  Press “Enter (Green)” key when prompted to save changes.

11.)  Press “Cancel (Red)” key once. The device should reboot.