DC Direct Setup - Pax IM30 - Ethernet

DC Direct Set-up Guide / PAX IM-30 Ethernet

DC Direct Setup - PAX IM-30 - Ethernet

What do you need to connect the PAX IM-30 via Ethernet?

Configured network and router
Network name and password
PAX IM-30 configured with Datacap keys and the appropriate Datacap ECN
Ethernet cable(s)

Connect Ethernet cable

1 Connect an Ethernet cable to the IM-30's back plate LAN port and to your network.

If using DHCP, no further setup should be required (Ethernet w/ DHCP is enabled by default). If using Static, continue to the next steps.

Access Android Desktop

1 Swipe up from the bottom of the screen.

2 Touch the back key ◁ twice.

3 When prompted for Back Desktop password type "pax9876@@". Touch "Enter".

Note: “123456” may work on some devices as passwords may vary. For EVO Snap devices, use “EVO72963687” for the password.

Connect to Ethernet

1 From the Android Desktop, touch "Settings".

2 When prompted for password, type"pax9876@@". Touch "OK".

Note: “123456” may work on some devices as passwords may vary. For EVO Snap devices, use “EVO72963687” for the password.

3 Touch "Ethernet" > "Ethernet IP Mode".

4 Select "Static".

Enter the values for the following:

IP address
Gateway
Network prefix length (this is your subnet mask in CIDR notation)
DNS 1
DNS 2

5 Touch "Connect".

6 Touch the home button ○ to return to Android Desktop.

Pair POS and DC Direct

Configure your Point of Sale using the DeviceID, the corresponding Merchant IDs (MIDS), and Terminal IDS (TIDS).

If using Wi-Fi or Ethernet connected PIN Pads, configure your POS with the corresponding IP addresses and port numbers from Step 4 above.

1 Tap the DC Direct app from the Android Desktop To view the DeviceID (serial #) and connected IP address.

2 Touch the home button ○ to return to Android Desktop.

3 Touch "PXRetailer" to return to Welcome Screen.

If you need help pairing DC Direct, contact your POS provider for specific instructions.

Run a Test Transaction

Initiate a $1.00 test sale from your POS.

Verify that all test transactions successfully reached NETePay Hosted™. Login to your dashboard via Datacap's Reportal to view transactions. Contact your processor to confirm that all transactions were received and the appropriate accounts were funded.