1.) Press the “1”, “5”, and “9” keys at the same time to open settings.
2.) Select “Control Panel” (scroll down if needed by dragging your finger upward).
3.) Select “Sysmode” (scroll down if needed by dragging your finger upward).
4.) Select “supervisor”.
5.) Type the supervisor password and press the “Enter (green)” key. This password can vary.
“1111111” OR
“1166832” OR
“1668321” OR
“1686321” OR
“1673491”
6.) Select “Administration”.
7.) Select “Config Editor”.
8.) Select “config.usr1”.
9.) Select “sacom” by touching its current value (scroll down if needed by dragging your finger upward).
10.) Select “Modify”.
11.) Type “IP” (To cycle through lower case, upper case, and number press the “#” key)
12.) Press the “Enter (green)” key.
13.) Press the “Cancel(red)” key 2 times to reach the administration menu.
14.) Select “Communications”.
15.) Select “Ethernet”.
16.) Select “eth0″.
17.) Select “Mode”.
18.) Enter your static values for the following fields:
IP Address
Mask
Gateway
DNS1
DNS2
19.) Press the “Cancel (red)” key.
20.) If prompted “Do you want to save changes?” select “Ok”.
21.) If prompted “Configure another interface? Select “No”.
22.) Press the “Cancel (red)” key twice to reach the main menu.
23.) Select “Exit”.
24.) Select “Reboot”.
Note: The P400 listens on TCP/IP port 12345 for requests. Normally this can be changed by setting “saport” but this doesn’t appear to be the case in XPI 19.
