Installing the Ingenico Driver

Prior to connecting an Ingenico device, the Ingenico driver will have to be installed on your PC. The driver is available for download here and is located under “Device Drivers” (Ingenico Telium 2 Line). 

Follow the Instructions below for Installing the Ingenico Driver:

1.      Download the Ingenico Jungo Driver here under “Device Drivers”.

2.      Select “Next” to continue with the Driver Setup Wizard.

 Ingenico Driver Setup Wizard
Ingenico Driver Setup Wizard

3.      Click “Next” to accept the default install location.

 Choose Install Location in Ingenico Setup Wizard
Choose Install Location in Ingenico Setup Wizard

4.      Install the driver with “Usb Driver parameters” configured as shown below substituting a COM port number not already in use in the bottom left corner.

a.  Check “Force COM Port Feature enabled”.

b. Enter the desired (and available) COM number in the left most box of “Select by Connection Order”.

c. Click “Next”.

 Usb Driver Parameters in Ingenico Setup Wizard
USB Driver Parameters in Ingenico Setup Wizard

NOTE: The above settings tells the Jungo driver that any supported device which is connected should be COM 9 in this case.

5.      Uncheck “Uninstall Microsoft Usbser driver(s)” then Click “Next”.

 Advanced Parameters in Ingenico Setup Wizard
Advanced Parameters in Ingenico Setup Wizard

6.      Click “Install” to accept the default start menu folder and install the driver.

 Choose Start Menu Folder in Ingenico Setup Wizard
Choose Start Menu Folder in Ingenico Setup Wizard


7.      Click “Finish”.

 Completing the Ingenico USB Drivers 3.11 Setup Wizard
Completing the Ingenico USB Drivers 3.11 Setup Wizard
 

Still need help?

How can we help?

Call us (215-997-8989) or Send us a message